Shaft Cones Variable Length

  • #
    PTO cone guards and PTO caps

Technical draw

###

Shaft cones variable length is constituted by a rigid plastic band of variable width that surrounds the PTO in accordance with Machinery Directive 2006/42/CE, fixed to a steel bottom by means of two bolts.
Once detached from the steel bottom, the plastic band can slide on the transmission to allow access to the joint and to the possible torque limiter or free wheel during the installation and maintenance operations.

Operating Instructions
1 – Damaged Guard not be used and should be immediately replaced.
2 – Do not step on Cone Guards.
3 – Cone Guard must overlap with Shaft Guard of minimum 50mm.
4 – Mounting: ensure both screws and washers are properly tightened onto flat face of the Guard.

Upon request, our PTO Cone Guards are supplied with Instructions Manual and Certificate of Conformity (CE 89/392, 91/368, 93/94 e 93/68).

To have Instructions Manual and Certificate of Conformity included, simply add “CE” to our part number (i.e. MP02755 is supplied without any document, MP02755CE is supplied with Manual and Certificate of Conformity).

Related products